Universal Adhesive PDF Print E-mail

For use with the total etch technique. Light cured hydrophobic resin bonds dentine, composites, resin based luting materials and silanated porcelain.

  • Fast and simple to use
  • One step for enamel
  • Two steps for dentine – use a dentine primer
  • High adhesive strength


Universal Adhesive bottle (7ml) BUA7B

Contents:

  • 1 x 7ml bottle

Instructions for use

INTRODUCTION

SP Bond is an acrylic resin-based self-priming bond that can be used to bond composite restorations to dentine and enamel.

INSTRUCTIONS

Step 1: Isolate the restoration using your preferred method.
Step 2: Prepare the cavity with minimum tooth reduction. Bevel cavosurface-enamel margins.
Step 3: Following the manufacturer’s instructions, etch the dentine for 15 seconds and enamel surfaces for at least 20 seconds with BDT’s 37% phosphoric acid Etching Gel, or similar. Rinse thoroughly. Blot excess moisture leaving the tooth moist.
Note: Highly fluoridated enamel may require longer etch times to achieve the desired etch pattern.
Step 4: Using a fully-saturated brush tip for each coat, apply two coats of SP Bond to the dentine and enamel surfaces. Dry gently with clean, dry air for 3-5 seconds after each coat.
Step 5: Light cure for 10 seconds.
Step 6: Place the composite restoration following the manufacturer’s instructions for placement, curing and finishing. Always replace the cap after use.

STORAGE

Store below 25°C (77°F) and out of intense light.

 

< Prev   Next >