Self Priming bond provides a high strength bond between dentine or enamel and all restorative materials.

SP Bond bottle (7ml) BSP7B

• Low viscosity, hydrophilic formulation
• Ethanol based
• Use in all applications including composites, veneers and silanated porcelain
• No primer needed
• Strong, durable bond
• Low film thickness

Contents:

1 x 7ml bottle

Instructions for use

INTRODUCTION

INSTRUCTIONS

Step 1: Isolate the restoration using your preferred method.

Step 2: Prepare the cavity with minimum tooth reduction. Bevel cavosurface-enamel margins.

Step 3: Following the manufacturer’s instructions, etch the dentine for 15 seconds and enamel surfaces for at least 20 seconds with BDT’s 37% phosphoric acid Etching Gel, or similar. Rinse thoroughly. Blot excess moisture leaving the tooth moist.

Note: Highly fluoridated enamel may require longer etch times to achieve the desired etch pattern.

Step 4: Using a fully-saturated brush tip for each coat, apply two coats of SP Bond to the dentine and enamel surfaces. Dry gently with clean, dry air for 3-5 seconds after each coat.

Step 5: Light cure for 10 seconds.

Step 6: Place the composite restoration following the manufacturer’s instructions for placement, curing and finishing. Always replace the cap after use.

STORAGE

Store below 25°C (77°F) and out of intense light.